Where do you connect the wires for a stepper motor. My Unipolar stepper has 6 wires, 2 are common, and the others are A-, A+, B-, and B+. I have connected these wires to the UNIPOLAR OUT of the Driver Board. However, in the manual, it says "Power to the motor is provided through the UP-PWR inputs." Which wires do I connect to the UP-PWR inputs?

I am having the same problem for driving a 4 wire bipolar motor.

Views: 284

Reply to This

Replies to This Discussion

That is correct. By connecting the power supply to the UP-PWR ports and the stepper motor's wires to the UNIPOLAR OUT of the Driver Board, I was able to drive each stepper motor individually. 

I am currently using a microcontroller and four L298 ICs to drive four bipolar stepper motors simultaneously in my project to make a 4-axis Hot Wire Foam Cutter :)

-- Yasir M

Joel Cheriyan said:

I believe the UP-PWR ports connect directly to your power supply, positive and ground

Attachments:

RSS

© 2021   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service