Enviro p3 pellet stove manual

* This manual is designed for the home owner in conjunction with the technical manual. * RATING LABEL LOCATION: The rating label is located on the hopper top behind the surround panel. PELLET QUALITY: Pellet quality is important, please read the following: Your Enviro pellet stove has been designed to burn 1⁄4" (6mm) dia wood pellets only Store pellets at least 36 (1 m) away from the pellet stove. AUTOMATIC SAFETY FEATURES: Your pellet Stove has the following safety features: A) The stove will shut off when the fire goes out and the exhaust temperature drops below 120 °F (49°C). B) The stove has a high temperature safety switch. If the temperature on the hopper reaches 200 °F Attach the hopper brackets to the back of the unit with a screw in each top holes of the brackets (#1 in Figure 33). Do not tighten these screws until all six (6) screws are in place. 2. Lay the hopper lid in place, slide the bushing into the bracket, and attach the lid to the brackets (#2 in Figure 33). operate the stove again until you are certain the chimney and its lining have not been damaged. FUEL: This pellet stove is designed and approved to only burn wood pellet fuel with up to 3% ash content. Dirty fuel will adversely affect the operation and performance of the unit and may void the warranty. Check with your dealer for fuel Enviro P3. smwilliamson. Apr 9, 2014. Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment. We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues. If nothing happens when you press the on/off button or the stove doesn't start heating, first check to make sure that the stove is plugged in all the way. You can also plug the stove into a different wall outlet or check to make sure a fuse has not blown. Next, if thermostat mode is on, make sure the thermostat is turned up enough to cause the AUTOMATIC SAFETY FEATURES OF YOUR PELLET STOVE A. With the aut o/manual switch in the auto positio n, the stove will shut off when the fire goes out and the exhaust temperature drops below 120° F (49 qC). If the switch is in the manual position , the stove will continue to feed pellets into the bur n pot after t he exhaust temperature drops with broken glass. The stove uses ceramic glass. Replacement glass must be purchased from an ENVIRO dealer. Do not attempt to open the door and clean the glass while the unit is in operation or if glass is hot. To clean the glass, use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner, * This manual is designed for the home owner in conjunction with the technical manual. * Rating LabeL Location: The rating label is located on the hopper top behind the surround panel. PeLLet QuaLity: Pellet quality is important, please read the following: Your Enviro pellet stove has been designed to burn ¼" (6mm) dia wood pellets only. DO NOT Anyways, ended up with a new, red Enviro P3 installed today! So far so good, stove looks good and is throwing out some serious heat! This being my first pellet stove, I've spent a lot of time observing it and trying a few things. Ran it on manual high (L5) for the first hour as per the installers, smoked up the house a bit but that's cleared up