Plantronics voyager pairing instructions

Put headset into pairing mode - With headset on, push inward and hold Call Control Button until the headset begins to flash red and blue. Select "Add new device" on your phone. Select the Plantronics headset when prompted. Enter "0000" as passcode. Your 520 headset will now have a continuous blue light blinking. Tap and hold the headphones to the phone's NFC tag location until NFC pairing completes. If necessary, accept the connection. TIP Keep an eye on your Smartphone's screen for prompts to start and accept the pairing process. NOTE The headphone's NFC tag is located on the outside of the left ear cup. Phone NFC tag locations vary. Pair mode Put your headset in pair mode. 3. Put your Bluetooth USB adapter into pair mode by pressing and holding the recessed pair button with a pen or paperclip until the Bluetooth USB adapter flashes red and blue. NOTEAdapter design may vary Pairing is successful when you hear "pairing successful" and "PC connected" and the Bluetooth USB adapter LED Manual. View the manual for the Plantronics Voyager EDGE here, for free. This manual comes under the category Headphones and has been rated by 7 people with an average of a 8.6. This manual is available in the following languages: English. Put your Bluetooth USB adapter into pair mode by selecting "Pair" in Poly Lens App. Your adapter flashes red and blue. Pairing is successful when you hear "pairing successful" and "PC connected" and the Bluetooth USB adapter LED is solid. Pair mode Slide and hold the headset Power switch away from the off position until the LEDs flash red and blue. Put your headphones in pair mode. Put your Bluetooth USB adapter into pair mode by gently pressing and holding the pair button with a pen or paperclip until the Bluetooth USB adapter flashes red and blue. Pairing is successful when you hear "pairing successful" and the Bluetooth USB adapter LED is solid blue. Fit and charge 1Switch on your headset then choose: • Tap the Voice button and say "Pair mode," or • Press and hold the Call button until you hear "Pairing" 2While the headset LEDs are flashing red and blue, activate Bluetooth®on your phone and set it to search for new devices. 3Select "PLT_Legend." Step 1 With the BT600 USB Adapter plugged into your laptop or computer, press and hold the button on the side of the BT600 for 3-5 seconds. The BT600 will start flashing red and blue, indicating that it's in pairing mode. Note* The button is quite small, so we recommend using something like a paperclip or pen tip to hold down the button! Step 2 Note: In some circumstances the pairing process can take up to two minutes to complete. 3. When the phone display asks for a passkey, enter: 0000. Status indicator flashes blue, once the headset is successfully paired. If pairing fails, try again starting with Step 1. Voyager 510S Bluetooth Headset System Poly recently launched its Voyager Office Base as an additional accessory, for those who own a Poly Voyager Focus 2 Office, will find this item very familiar as is the same base that yo used to find in that particular model.The reason of this is that the end user can get another base and keep using the headset in the office, out the office or wherever has the need to use the headset with Pairing Your Headset 3 Use the commands on your phone to locate your headset. For most phones, select Settings/Tools > 1 Devices > Bluetooth > PROPlantronics. See your phon