Reese friction sway control installation instructions

Proactive Sway Control. Unlike reactive sway control systems, proactive sway controllers prevent the trailer from swaying in the first place. Diagram 4: Hayman Reese Friction Sway Controller. Diagram 5: Hayman Reese Dual Cam High-Performance™ Sway Control system . Hayman Reese 1800 812 017 info@haymanreese.com.au 49 Pacific Drive Installation Instructions REESE Dual Cam HP High-Performance Sway Control 2. Install 2 lock nuts per U-bolt, tighten u-bolt nuts. Make sure at least 2 threads are showing past the ends of the nuts. 4. If the adjustment is difficult, as the adjustment nut must be turned by hand, apply a small amount of light penetrating oil such. Bolt-on sway control adapter attaches to standard 2 inch ball mounts to provide a mounting point for friction sway controls. The ball mount platform must be 2-1/2" wide and have a 1" ball hole. The adapter is made of 3/8" thick material and mounts under the hitch ball. When installed, the shank length of the hitch ball must be long enough to 1/4 turn increments in the direction shown on the label until the desired control is achieved. For large. trailers, it may be necessary to install a second sway control unit. b. After about 1000 miles of towing, remove the slide bar from the sway control and clean the friction surfaces. with a wire brush. OPERATING INSTRUCTIONS Hook up the trailer to the tow vehicle. Lubricate the threads on the handle with a drop of oil. Attach the socket on the slide bar to the sway control ball on the ball mount. Secure in place, using a spring clip. Turn the On/Off handle 3 turns counter clockwise to release tension. Some get 2 kits; 1 for the left side and 1 for the right side. This kit includes everything you need to help reduce the sway when towing your camper trailer. Kit includes the sway control arm, mini ball (1-1/4″ ball) for the sway control tab. Again two kits are recommended for larger trailers. This works with or without a weight-distribution INSTALLATION INSTRUCTIONS Product No. 26000 You can take it with you. 26001 ELKHART, IN., OAKVILLE, ONT. DUAL CAM SWAY CONTROL ASSEMBLY: 1. Assemble clevis through chain. Attach clevis to cam arm assembly with 3/8" bolt and 3/8" locknut as shown (Make sure clevis can move freely). 2. Attach pivot brackets to each side of trailer frame using