Gifts Received

Jerry Fan has not received any gifts yet

Give a Gift

Jerry Fan's Page

Comment Wall (1 comment)

You need to be a member of Personal Mechatronics Lab to add comments!

Join Personal Mechatronics Lab

At 5:01pm on February 21, 2013, Yifan Wang said…: Hi Jerry,

I tried to sent out a group email, but your email address at

jiacheng.fan@utoronto.ca

rejected the email.

I have attached the email below, and please email me your up-to-date email address at: yf.wang@mail.utoronto.ca

Hi All,

Just a few words on what should be presented on the upcoming evaluation:

ElectroMech:

- The machine should be complete

- All modules should be able to function properly

- One manual run must be demonstrated from start to end

- Modules need not to be permanently mounted, but all cuts and drills must be made (eg. side walls, removable modules)

Circuit:

- All circuit should be soldered

- All circuit should be functional

- One demo run from start to end (eg. sensor A output triggers motor A ect... you don't have to integrate the circuits, but you do need to demonstrate that sensor will produce logic high, and motor will run on logic high etc.. )

MicroController:

- All code should be complete (including RTC, EEPROM if you wish to include them)

- All code should be functional

- One demo run of code from start to end (You can use the debug switch to simulate the sensor input, and use the Driver board to simulate the motor)

Same as last time, there will be four time slot, 30 minutes each, and they will be filled on a first come first serve basis. Please note that this is your last chance - excluding Notebook eval - to earn marks as individual, please be as prepared as you can.

If you have any questions, or any special circumstances that I should know about, please email me.

--
-Robert