Quick question, for those of you who are using the 12 V adaptor to power up your devbugger, has any of you encountered the problem when sometimes you switch off the power and turn it back on the LCD turns on but doesn't display anything? But if you unplug and plug the cable it will show something again...

Views: 207

Reply to This

Replies to This Discussion

Yeah I've seen that issue.  Did you just lop off the adapter part and use the wires?

i used a two-pin connector that goes in the adaptor like this one http://www.ebay.com/bhp/12v-dc-connector

 

 and just connect those two pins to 12V and ground

RSS

© 2024   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service